In this section, you are presented with the information to configure the features described in this document. Refer to the Cisco Technical Tips Conventions for more information on document conventions. If your network is live, make sure that you understand the potential impact of any command. All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment. From this point on, the client program sends its RPC queries to that new port. The client sends the RPC program number of the service, and gets back the port number. It does this by querying the portmapper process on the well-known port number 111. When a client attempts to access an RPC service on a server, it must find out which port that particular service runs on. Sun RPC services can run on any port on the system. The inspect sunrpc command enables or disables application inspection for the Sun RPC protocol. Note: PIX 7.0 uses the inspect rpc command to handle RPC packets. If they do not work separately, they do not work together. The configuration also works for PIX Software Release 5.1.x, except for the Cisco VPN 3000 Client part.) IPsec and PPTP/Microsoft Point-to-Point Encryption (MPPE) should be made to work separately first. (Support for the Cisco VPN 3000 Client 2.5 is added in PIX Software Release 5.2.x. PIX Software Release 6.x is required for the Cisco VPN Client 3.x and 4.x. Note: This was tested on PIX Software Release 6.3.3 but should work on release 5.2.x and 5.3.1. Microsoft Windows 2000 and Windows 98 clients The information in this document is based on these software and hardware versions: There are no specific requirements for this document. ![]() However, the pools can also be made separate. In this example, a single pool for IPsec and PPTP is configured. Users that run the Cisco VPN Client 3.x/4.x on Windows 95/98/NT/2000/XP Users that run native Windows 98/2000/XP Point-to-Point Tunneling Protocol (PPTP) clients Users that run the Cisco Secure VPN 3000 Client 2.5.x on Windows 95/98/NT Users that run Cisco Secure VPN Client 1.1 on Microsoft Windows 95/98/NT In this sample configuration, four different kinds of clients connect and encrypt traffic with the Cisco Secure PIX Firewall as tunnel endpoint:
0 Comments
Leave a Reply. |